I'm trying to use a CanaKit USB wifi dongle on a headless model 1B+ Pi running Bullseye (OS release 2024-03-12). The chipset of the USB wifi dongle is the Ralink 5370. I used the Pi Imager to configure the wireless network settings. When connected to the router with ethernet, the USB device is recognized with and shows a wlan0 connection to my wireless network. However, if I disconnect the ethernet cable, reboot, and then try to ssh into the Pi, I get What do I need to do to get a wifi-only connection with this setup? My knowledge of networking is below the beginner level, so guidance on how to get wifi capability on this old B+ would be appreciated. Thank you.
Code:
lsusbCode:
iwgetidCode:
ssh: connect to host 10.X.X.X port 22: No route to host.Statistics: Posted by MacsandaPi — Sun May 19, 2024 10:51 pm