Hi,
On my Custom design CM4 Board, I connected the camera connection via CAM0 pins and connected the I2C connection to GPIO44 and 45. Yes I know, normally I should have connected to GPIO0 and 1. However, I wanted to ask if I can change the I2C pins in software to run the camera without the need for HW Revision.
There is something about I2C Swap in the following link but I think it is not for CM4. https://www.raspberrypi.com/documentati ... -gpio-pins
I hope there is an easy way HW revision is very difficult now.
In summary, the camera data pins are connected to the CAM0 Line, the I2C pins are connected to SCL0 SDA0 (GPIO44 45, Connector pin 80 82) and I want to run the camera, what can I do? I am using Official RPi Camera v2.1.
On my Custom design CM4 Board, I connected the camera connection via CAM0 pins and connected the I2C connection to GPIO44 and 45. Yes I know, normally I should have connected to GPIO0 and 1. However, I wanted to ask if I can change the I2C pins in software to run the camera without the need for HW Revision.
There is something about I2C Swap in the following link but I think it is not for CM4. https://www.raspberrypi.com/documentati ... -gpio-pins
I hope there is an easy way HW revision is very difficult now.
In summary, the camera data pins are connected to the CAM0 Line, the I2C pins are connected to SCL0 SDA0 (GPIO44 45, Connector pin 80 82) and I want to run the camera, what can I do? I am using Official RPi Camera v2.1.
Statistics: Posted by mcnpower — Sat Aug 17, 2024 6:28 pm