Scratch the below... It's working now. The second `sudo rpi-update pulls/6027` must have done the trick, maybe I was seeing a still shot from before the reboot.
Note, though, that even with the original `sudo rpi-update pulls/6027`, I needed to do it a second time when I attached a second camera.
Note, though, that even with the original `sudo rpi-update pulls/6027`, I needed to do it a second time when I attached a second camera.
OK, I am having the upside-down blueberry issue again with the RPi GS camera. This is the *same camera and RPi as my previous post, after the update fixed it*. The difference is now I connected a SECOND camera--an RPi 3 Camera module to the CAMERA0 slot. The RPi GS was on CAMERA1 physical slot before and still is now. The GS was previously listed as Camera 0 using the `rpicam-vid --list-cameras` command, now it is is listed as Camera 1 (see below).
I tried running again `sudo rpi-update pulls/6027`, but it stated it was already on that version. So, I ran a `sudo rpi-update` and reboot to get it back to the current, then ran `sudo rpi-update pulls/6027` and reboot, to which it updated. However, this did not fix my issue.
Is there some reason this update didn't work because the RPi GS Camera is now the second camera? @naushir
These are currently my 2 camerasCode:
Available cameras-----------------0 : imx708 [4608x2592 10-bit] (/base/axi/pcie@120000/rp1/i2c@88000/imx708@1a) Modes: 'SBGGR10_CSI2P' : 1536x864 [30.00 fps - (0, 0)/0x0 crop] 2304x1296 [30.00 fps - (0, 0)/0x0 crop] 4608x2592 [30.00 fps - (0, 0)/0x0 crop]1 : imx296 [1456x1088 10-bit] (/base/axi/pcie@120000/rp1/i2c@80000/imx296@1a) Modes: 'SBGGR10_CSI2P' : 1456x1088 [30.00 fps - (0, 0)/0x0 crop]
Statistics: Posted by glitteryio — Tue Mar 26, 2024 8:00 pm
